Look
for the UltraMag label on our magnetic connector products
which are designed with our patent pending modular design
assembly process. The Ultramag assembly process reduces
the time required for the production of these connectors.
This process provides Xmultiple with the capability to
reduce lead-times dramatically. How it works is simple.
The process insures each connector can be tested before
the final assembly of the magnetics. We use this UltraMag
process to test before we insert the magnetics into the
connector exterior housing. The magnetics and contacts
of the connector are assembled in a modular section. After
this final functional magnetic testing the units are placed
in the connector completing the final assembly. UltraMag
production volume levels are increased compared to competitive
products not assembled with this process. The UltraMag
system of assembly assures the magnetics are 100% tested
before the final assembly and therefore eliminating the
need to disassemble a final connector after discovering
the magnetics does not test at 100% performance. The production
time saved is critical to providing our customers with
the products they need when they need them.
Magnetic Connectors with Tab-Up and Tab Down - with/without
LED's - with/without EMI tabs
Single port, Multi-port and Stackable configurations (Thru-hole)
Reduces the number of components to be placed on the board
Frees up board space and offers signal protection
Noise reduction in the system
Improved reliability and optimal system performance
Benefits of having shorter signal paths and the reliability
gains from systems containing fewer components
Helps manufacturers reach their goals of cost reduction
